Tim Ellison

Content provided by Eduardo, KC8R I have a FLEX-6300 running SmartSDR for Windows and have been using 2Tone as the MMTTY replacement with N1MM, but I am guessing the configuration is the same. Bel...

These instructions are for Windows 11 but are similar to previous versions of Windows.1.) Shut down SmartSDR and the FLEX-8000/6000.2.) In the Windows Control panel, go to "Programs and Features" o...

Information provided by: Paul, W9AC Amplifiers can damage a FLEX-6000 TX Relay line if the amplifier has too much relay control voltage, voltage spikes, or excessive current on the relay control l...

By Steve Hicks, N5AC Just a note here to explain for anyone trying to optimize or reduce network bandwidth how much control you have over the bandwidth. The SmartSDR architecture was designed to a...

Content provided by Tom, W4TMW The information provided below can be used to Interface an Elecraft XV144 transverter to a FLEX-6300 Hardware Interface IF connections The FLEX-6300 can only be conne...

Content provided by: Bobby OwsinskiThe following excerpt from "The Mixing Engineer's Handbook" by engineer Bobby Owsinski discusses how EQ can affect different frequencies in an audio mix. A Tips a...

Article by: EA4GLI / 8P9EH - Salvador I recently purchased a FLEX-6300 and was at first disappointed with the performance of the waterfall display and panadapter. I had to lower the speed and FPS ...

The SmartSDR LAN Remote feature uses the Windows default Playback (speaker / headphones) and Recording (microphone) audio devices.   In general, on Win7 and Win 8.x PCs, when plugging a headset in...

The ability to turn on or off your radio while operating remotely is a necessary convenience when using SmartLink.The FLEX-8000 and FLEX-6000 Signature Series SDRs have a connector, REM ON (REMote ...

As more features are added to the FLEX-8000 and FLEX-6000 Signature Series SDRs, depending on the feature, there may be increases in the amount of bandwidth utilized between the radio and the clien...