"How To" Articles
Various tips and tricks from users.
- How to Set Confirm Exit in SmartSDR CAT & DAX
- How to Configure NTP Time Sources
- How to Use CW Profiles
- How to Assign the Toggle Breakin F-Key
- How to Set PTT Override
- How to Set Noise Floor Range
- How to Use the DSP Controls Panel
- How to Use the Auto AGC-T Feature
- How to Use the AutoDX (ADX) Feature
- Upgrading your FLEX-6000/8000/Aurora Radio using SmartSDR for Mac
- How to Uninstall SmartSDR v4.2.18 and Greater
- How to Use the Transmit Filter Bandwidth Display Feature
- How to Setup the User Configurable Receive Filters
- How to Use the Band-Plan Feature
- Configuring SmartSignal APD for FlexRadio 8000 and the Power Genius XL Amplifier
- How to Install SmartSDR v4.2.18
- How to Use the Serial Pass-Through Feature
- How to Upgrade the Software/Firmware on an M-Model Radio
- How to Set Up SmartLink
- Exporting and Importing your SmartSDR Profiles
- How to Factory Reset your FLEX-6000/FLEX-8000 Radio
- Getting Started with the FLEX-6000
- Configuring the USB Cables Feature for the FLEX-6000/FLEX-8000
- How to Determine the Correct Amount of RF Preamp Gain for Different Band Conditions
- Gathering Information About Your Computer
- How to Configure HRD using DAXv2
- The FreeDV Waveform.
- How to Configure FLDIGI for FLEX-6000/8000/Aurora Radios with DAXv2
- How to Configure MMSSTV for FLEX-6000/8000/Aurora Radios using DAXv2
- Configuring MMTTY for FLEX-6000/8000/Aurora Radios with DAXv2