Tim Ellison

Content provided by: Kari, SM0HRP Assumptions: You use Writelog version 12.20 D or later. SDR 2.0.19.98. TX delay has been set to 0 ms.This article applies to dual SCU radios, like the FLEX-6700, F...

If you have your radio connected directly to your computer which has wifi Internet access and you need your radio to access the Internet to download a SmartSDR license, you will need to configure p...

In order for remote access to a FLEX-6000 to work using SmartLink, the Internet router where your radio is located must be able to accept an outside connection from the Internet in order to make a ...

After installing SmartSDR for Windows, you may encounter a warning that the kernel-mode WDM DAX driver does not have a valid digital signature and Windows renders the driver unavailable. First off,...

In order to keep your FLEX-6000 operating optimally, periodic cleaning to remove accumulated dust is recommended.  Usually, a once-a-year cleaning is sufficient when the radio is used in a conditio...

Each time when you connect a new COM device or a USB device (true for modems, smartphones, Bluetooth, serial-to-USB converters, etc.), Windows detects it using Plug-n-Play and assigns it a COM port...

The following table describes the pinouts on the modular FLEX-3000 & FLEX-1500 RJ-45 8-pin microphone connector.     FLEX-3000/1500 Microphone Pinout Configuration Pin Number Function 1 ...

  FLEX-5000 RX2 The FLEX-5000 Second Receiver (RX2) is, in fact, an entirely independent software defined radio receiver that is equal in performance to the outstanding receiver found in the FLEX-5...

Content provided by: FlexRadio Systems The following procedure will uninstall the FLEX Firewire device driver form your computer. The following screen shots are from Windows XP, but the process is...

Content provided by: Richard, AE6XO   The following is a step-by-step guide for configuring PowerSDR for WINMOR when using a FLEX-3000 or FLEX-5000. 1. Create a virtual audio cable pair using th...