"How To" Articles
Various tips and tricks from users.
- Configuring WSJT-X for the Aurora and FLEX Series Radios using DAXv2
- How to use a PC or USB Mic with SmartSDR
- How to Operate Digital and Voice modes at the Same Time on the Same Frequency
- Using the CWX and WinKeyer Prosigns
- Connecting "Balanced" Microphones to Flex 6000 / 8000 / Aurora Radios
- How to Connect a radiosport RS60CF-10A to a Maestro C
- How to Configure N1MM+ to Display Spots on the SmartSDR Panadapter
- Using Rufus to Install a Bootable Image to a USB Drive
- How to Connect 3rd Party Microphones with Two-Connector MONO (TS) or Three-Connector "Balanced" TRS Plugs to the Maestro C
- How To Configure MMSSTV (Slow Scan) for the FLEX-6000/8000 Series Radios
- Configuring MMTTY for the FLEX-6000/8000 Radios
- Using a FLEX-8000 as an NTP Server
- How to Connect your FHM-3 Microphone to the Maestro C
- How to Configure FlDigi for the FLEX-6000/8000 Radios
- How to use DSP to Improve CW Reception in High Noise / Weak Signal Environments
- How to Set up PTT output in SSDR for Windows for 3rd Party Amplifiers or Transverters.
- How to Mitigate Common Mode Interference
- How to Take a Screen Capture of your SmartSDR Screens
- Configuring WSJT-X for the Aurora and FLEX Series Radios
- INRAD 629 4-pin XLR Wiring Diagram
- Adjusting your Microphone Settings for Best TX Audio
- Using the ATU on the FLEX-6000/FLEX-8000/AURORA Radio Series
- Using Digital Programs on a Windows computer with slices controlled by another SmartSDR client
- Remote Operation: Working around CGNAT - is it possible?
- Configuring a FLEX-6000 for FT8 on a Mac with dogparkSDR, MacLogger and WSJT-X
- ARRL FMT Technique with FLEX-6000 Series Radios
- The Correct Power Up and Power Down Sequence for FLEX-6000 "M" Model Radios
- Enabling the Windows Audio Recording (Microphone) Devices
- Best Practice for Surviving a Windows 10 Major Update
- Manually Re-charging the Maestro "A" Internal Battery